According to standards set by the federal government, a low-flow showerhead uses no more than 2.5 gallons of water per minute at a water pressure of 80 pounds per square inch. That’s less than half the rate of water used by some older traditional showerhead models. Low-flow showerheads come in two main types, aerating, which creates a mist, or laminar-flow that sends water out in a steady stream.
Try a plunger: If it's a double sink, use a wet rag or rubber stopper to block the other drain. Place the plunger directly over the drain until it forms an air-tight seal. If you have trouble forming an air-tight seal with the plunger, run it under some hot water to make it more flexible. Move the plunger up and down to dislodge the clog from the drain.
Seriously, I've done a lot of plumbing repairs, from installing sinks and fixtures, toilet replacement and repair, caulking and recaulking to replacing a garbage disposal. Probably the most frustrating thing I've encountered was needing a specialty tool for one repair; for me it was a basin wrench. Some hardware stores will loan tools, so it's worth it to find that out ahead of time.
Awesome experience with Charlie's Rooter Service! Our outside area drains were overflowing when it rained and about to flood toward the house.  I called Charlie's and they had Luis come over within an hour.  Luis was super friendly and ready to help when he arrived.  He figured out the problem and snaked the street drain and pulled out a huge clump of roots that were clogging it up!  But there was still some backup flooding on the side that he was able to isolate to get rid of the mud and debris that were clogging that up.  Before leaving, Luis even gave suggestions on how to flush it out periodically to keep things flowing smoothly.  Luis is the best and I would definitely use him for future plumbing problems, highly recommended!

Plumbing Service

×